Golf Carbon Fiber Triangle Putting Board Laser Groove Face Square Alignment Trainer.Use the laser to check where you are really aimed. Then put the laser away and use the board to train a square putter face.

Check your aim with the laser. Train your putt without it.
Aim first. Remove the laser. Then putt with confidence.
One board, two clear steps toward a better putting setup.

1. First, check your aim
Place the laser in the groove and use the light as a target-direction reference. This stage is for checking your stance and alignment only. Do not putt yet.

2. Then, remove the laser and putt
Once your setup is calibrated, take the laser off the board. Place the ball in the recess and use the three lines and triangle tip to set up for an actual putt.

3. No laser during impact practice
The laser is not used while putting. This keeps the putting phase simple and lets you focus on face direction and ball roll.

4. Three easy references
The ball recess helps keep the ball in a consistent position. The three lines help you check the putter face. The triangle tip points toward your target.

5. See the result of every putt
If the ball starts left or right of the intended line, you receive immediate feedback about the setup and face direction.

6. Pin the board in place
Use the two rear holes with tee pegs to stop the board from moving during practice.

7. Lightweight and easy to carry
The carbon fiber board weighs approximately 104g and comes with a protective sleeve for storage and transport.

8. Laser not included
The board is supplied without a laser. Choose a suitable laser pointer that complies with the rules in your country or region.

How to Use

Aim Calibration